The technique of using the Chuangrui peristaltic pump

When the Chuangrui Peristaltic Pump does not work, the pressure clamp can extend the service life of the Peristaltic Pump Hose. Peristaltic pump is by compressing peristaltic pump hose natural rebound to produce suction and fluid delivery, in order to maintain the life of the peristaltic pump hose, without the use of peristaltic pump, as far as possible the peristaltic pump pump briquetting, so that The peristaltic pump hose is naturally free from briquettes, thereby extending the service life of the peristaltic pump.

Chuangrui Peristaltic pump selection in the flow to meet the wall, as far as possible can make the speed of the peristaltic pump reduced to three hundred or so. The flow rate of the peristaltic pump is caused by the rotation of the Peristaltic Pump Head. If the rotation is faster, the use time of the peristaltic pump hose will be shorter, and when the peristaltic pump hose is expected to be used for a longer period of time, Peristaltic pump diameter, thereby reducing the speed of the peristaltic pump.

Chuangrui Peristaltic pump head with Peristaltic Pump Tube, the rest with ordinary pipes. Peristaltic pump used on the extrusion tube due to the need for good compression talks, tear resistance. So the purity of these pump tubes is relatively high, the wall thickness and shape accuracy is higher, which will cause the peristaltic pump tube prices higher. So the use of ordinary pipe to do the connection will be more economical.

The Chuangrui peristaltic pump tube inlet is as short as possible and the pipe joint and the caliber are not lower than the caliber of the tube loaded with the pump head. Peristaltic pump suction is generated by the pump tube rebound, if the pipeline, especially the inlet pipe is too long or smaller caliber, it will cause the suction end resistance is too large, the resistance is too large pump tube rebound will be blocked, so the actual delivery Traffic will be greatly lost. Similarly, if the outlet pipe is smaller or the pipe is too long, because the peristaltic pump discharge pressure is usually small, when the discharge resistance is too large will cause the output flow to reduce the phenomenon.

Please contact me if you need any help:www.crpump.com +86 15633705132 sales01@crpump.com