Some necessary checks of the newly purchased peristaltic pump, hose pump and peristaltic pump should be done prior to installation.
1. Whether the peristaltic pump shaft rotates properly or there is a blockage in the bearing.
2. Whether the
Peristaltic Pump Hose needs to be replaced more If the hose previously used when replacing the peristaltic pump is worn or cracked, replace the peristaltic pump hose or move part of the
Peristaltic Pump Head is needed. To avoid fatigue extrusion of the same hose by the pump head to achieve higher fluid permeability.
3. Check if the peristaltic pump operation switch is normal, and if the control panel control button and the power switch button are functioning properly. After checking the above and confirming that there are no abnormalities, you can use the
newly purchased
peristaltic pump and hose pump.
Peristaltic pump operation procedure
The operating mode of the peristaltic pump is as follows. Manual, external control, 0-5V, 4-20mA, 485 communication etc. Usually, the operation parameters are already set at the factory, so the user does not need to make another setting. Turn on the power, start / stop button You can operate normally just by pressing and pressing the acceleration or deceleration button ▲ or ▼. If you replace or use different specifications of silicone tubing, you need to readjust the flow parameters.